1 | Yatomi, M., Hojo, M., Tanaka, M., Ochiai, S., Sawada, Y. and Takahashi, J. |
| Influence of Heat Treatment Temperature on Fracture Mechanism of C/C Composites |
| Journal of the Society of Materials Science, Japan, Vol.47, No.9, pp.939-945 (1998) in Japanese. |
| |
2 | Ochiai, S., Okumura, I., Tanaka, M. and Hojo, M. |
| Influences of Residual Stresses, Frictional Shear Stress at Debonded Interface and Interactions among Broken Components on Interfacial Debonding in Unidirectional Multi-Filamentary Composites |
| Composite Interfaces, Vol.5, No.4, pp.363-381 (1998). |
| |
3 | Ochiai, S., Tanaka, M. and Hojo, M. |
| Effects of Residual Stress and Interfacial Frictional Shear Stress on Interfacial Debonding at Notch-Tip in Two-Dimensional Unidirectional Composite |
| Composite Interfaces, Vol.5, No.5, pp.437-460 (1998). |
| |
4 | Ochiai, S., Tanaka, M. and Hojo, M. |
| Approximate Solution of Interactions among Spatially Distributed Broken Fiber, Matrix and Interface in Progress of Interfacial Debonding in Multifilamentary Unidirectional Composites |
| JSME International Journal, Ser. A, Vol.43, No.1 (2000). |
| |
5 | Ochiai, S., Hojo, M. and Tanaka, M. |
| Mechanical Interactions Between Fiber and Cracked Coating Layer and Their Influences on Fiber Strength |
| Composites, Part A, Vol.30, pp.451-461 (1999). |
| |
6 | Tanaka, M., Ochiai, S., Hojo, M., Ishikawa, T., Kajii, S., Matsunaga, K. and Yamamura, T. |
| Fracture Behavior of Unidirectional Si-Ti-C-O Fiber-Bonded Ceramic Composite Materials |
| Key Engineering Materials, Vols.164-165, pp.141-144 (1999). |
| |
7 | Ochiai, S., Tanaka, M. and Hojo, M. |
| Modeling of Interfacial Debonding in Unidirectionally Fiber-reinforced Ceramics |
| Key Engineering Materials, Vols.164-165, pp.373-378 (1999). |
| |
8 | Tanaka, M., Ochiai, S., Hojo, M., Tanaka, R., Miyamura, K., Fujikura, M. and Nakayama H. |
| Fatigue and Creep Fracture Behavior of Plain-Woven SiC/SiC Composites at Room Temperature and 1473K |
| Journal of the Society of Materials Science, Japan, Vol.48, No.12, pp.1393-1399 (1999) in Japanese. |
| |
9 | Ochiai, S., Fujita, T., Tanaka, M., Hojo, M., Tanaka, R., Miyamura, K., Nakayama H., Yamamoto, M. and Fujikura, M. |
| Influences of Distribution of Fiber Strength and Residual Stresses on Tensile Strength of SiC Fiber-reinforced TiAl Matrix Composites |
| Journal of Japan Institute of Metals, Vol.63, No.12, pp.1567-1575 (1999) in Japanese. |
| |
10 | Ochiai, S., Fujita, T., Tanaka, M., Hojo, M., Tanaka, R., Miyamura, K., Nakayama H., Yamamoto, M. and Fujikura, M. |
| Monte Carlo Simulation of Tensile Fracture Behavior of Unidirectional Fiber Reinforced Brittle Matrix Composite with Weak Interface |
| Journal of Japan Institute of Metals, Vol.64, No.1, pp.7-14 (2000) in Japanese. |
| |
11 | Tanaka, M., Okumura, I., Ochiai, S., Hojo, M., Yamamura, T., Sato, M. and Tamura, M. |
| In-Situ Observation and Simulation of Tensile Fracture Behavior of Unidirectional Si-Ti-C-O/BMAS Composite Materials |
| Journal of the Society of Materials Science, Japan, Vol.49, No.5, pp.502-509 (2000) in Japanese. |
| |
12 | Ochiai, S., Kimura, S., Tanaka, M. and Hojo, M. |
| Simulation Study on Influence of Damage-Induced Mechanical Interactions, Residual Stress and Interfacial Frictional Shear Stress on Interfacial Debonding in Multifilamentary Composites |
| Materials Transactions, Vol.41, No.12, pp.100-107 (2000). |
| |
13 | Ochiai, S., Okumura, I., Tanaka, M., Hojo, M., Sato, M., Tamura, M., Kohtoku, Y. and Yamamura, T. |
| Fracture behavior of notched unidirectional Si-Ti-C-O/BMAS composite |
| Journal of Materials Science, Vol.35, pp.3497-3504 (2000). |
| |
14 | Ochiai, S., Tanaka, M. and Hojo, M. |
| Simulation Study on Interfacial Debonding Caused by Spatially Distributed Damages in Unidirectional Fiber-Composites Using 2D Model |
| International Journal of Materials and Product Technology, Vol.16. Nos.1-3, pp.139-148 (2001). |
| |
15 | Hojo, M., Yamao, T., Tanaka, M., Ochiai, S., Iwashita, N., and Sawada, Y. |
| Effect of Interface Control on Fracture Behavior of Woven C/C Composites |
| International Journal of Materials and Product Technology, Vol.16. Nos.1-3, pp.156-164 (2001). |
| |
16 | Tanaka, M., Ochiai, S., Hojo, M., Ishikawa, T., Kajii, S., Matsunaga, K. and Yamamura, T. |
| Observation and Analysis of Fracture Process of Fiber, Matrix and Interface in UD Si-Ti-C-O Fiber-Bonded Composite |
| International Journal of Materials and Product Technology, Vol.16. Nos.1-3, pp.223-231 (2001). |
| |
17 | Tanaka, M., Ochiai, S., Hojo, M., Ishikawa, T., Kajii, S., Matsunaga, K., Kohtoku, Y. and Yamamura, T. |
| Observation and Simulation of Tensile Fracture Process of Unidirectional Si-Ti-C-O Fiber-Bonded Ceramic Composite |
| Transactions of the Japan Society of Mechanical Engineers, Ser.A., Vol.67, No.655, pp.489-495 (2001) in Japanese. |
| |
18 | Hojo, M., Yamao, T., Tanaka, M., Ochiai, S., Iwashita, N., and Sawada, Y. |
| Effect of Interface Control on Mode I Interlaminar Fracture Toughness of Woven C/C Composite Laminates |
| JSME International Journal, Ser. A., Vol.44. No.4, pp.573-581 (2001). |
| |
19 | Tanaka, M., Hojo, M., Ochiai, S., Yamao, T., Iwashita, N. and Sawada, Y. |
| Study on Notched Strength of Woven C/C Composites by Means of the Modified Shear Lag Analysis Method |
| Transactions of the Japan Society of Mechanical Engineers, Ser.A, Vol.68, No.665, pp.111-118 (2002) in Japanese. |
| |
20 | Hojo, M., Yamao, T., Tanaka, M., Ochiai, S., Iwashita, N., and Sawada, Y. |
| Effects of Interface Control and Heat-Treatment Temperature on Interlaminar Shear Strength and Mode II Interlaminar Fracture Toughness of Woven C/C Composites |
| Materials Science Research International, Vol.7, No.1, pp.34-40 (2001). |
| |
21 | Ochiai, S., Tanaka, M., Tanaka, H., Kimura, S., and Hojo, M. |
| A Modeling Study on Residual Stress-induced Interfacial Debonding and Stress-strain Behavior of Weakly Bonded UD Composites |
| Composites Part A, Vol.33, No.10, pp.1337-1343 (2002). |
| |
22 | Ochiai, S., Tanaka, H., Kimura, S., Tanaka, M., Hojo, M. and Okuda, H. |
| Modeling of Residual Stress-Induced Stress-Strain Behavior of Unidirectional Brittle Fiber/Brittle Matrix Composite with Weak Interface |
| Composite Science and Technology, Vol.63, pp.1027-1040 (2003). |
| |
23 | Hojo, M., Nakamura, M., Matsuoka, T., Tanaka, M., Ochiai, S., Sugano, M. and Osamura, K. |
| Microscopic Fracture of Filaments and Its Relation to the Critical Current under Bending Deformation in (Bi,Pb)2Sr2Ca2Cu3O10 Composite Superconducting Tapes |
| Superconductor Science and Technology, Vol.16, Issue 9, pp.1043-1051 (2003). |
| |
24 | Ochiai, S., Kimura, S., Tanaka, H., Tanaka, M., Hojo, M., Morishita, K., Okuda, H., Nakayama, H., Tamura, M., Shibata, K. and Sato, M. |
| Degradation of SiC/SiC Composite Due to Exposure at High Temperatures in Vacuum in Comparison with That in Air |
| Composites Part A, Vol.35, Issue 1, pp.33-40 (2004). |
| |
25 | Ochiai, S., Kimura, S., Tanaka, H., Tanaka, M., Hojo, M., Morishita, K., Okuda, H., Nakayama, H., Tamura, M., Shibata, K. and Sato, M. |
| Residual Strength of PIP-processed SiC/SiC Single-tow Minicomposite Exposed at High Ttemperatures in Air as a Function of Exposure Temperature and Time |
| Composites Part A, Vol.35, Issue 1, pp.41-50 (2004). |
| |
26 | Ochiai, S., Hojo, M., Tanaka, M., Okuda, H., Schulte, K. and Fiedler, B. |
| Nondimensional Simulation of Tensile Behavior of UD Microcomposite under Energy Release Rate- and Shear Stress-Criteria for Interfacial Debonding |
| Composite Interfaces, Vol.11, No.2, pp.169-194 (2004). |
| |
27 | Ochiai, S., Okuda, H., Kimura, S., Morishita, K., Tanaka, M., Hojo, M. and Sato, M. |
| Improvement of Youngfs modulus and tensile strength of polymer impregnation and pyrolysis processed SiC/SiC composite by improved continuity of matrix |
| Journal of Materials Research, Vol.19, No.8, pp.2377-2388 (2004). |
| |
28 | Tanaka, M., Hojo, M., Hobbiebrunken, T., Ochiai, S., Hirosawa, Y., Fujita, K. and Sawada, Y. |
| Influence of Non-uniform Fiber Arrangement on Tensile Fracture Behavior of Unidirectional Fiber/epoxy Model Composites |
| Composite Interfaces, Vol.12, Nos.3-4, pp.365-378 (2005). |
| |
29 | Hojo, M., Nakamura, M., Tanaka, M., Adachi, T., Sugano, M., Ochiai, S. and Osamura, K. |
| Analysis of Mesoscopic Stress States with Delamination and Their Relation to Critical Current under Bending Deformation in Bi2223/Ag Superconducting Composite Tapes |
| Superconductor Science and Technology, Vol.18, No.12, pp.S356-S363 (2005). |
| |
30 | Hojo, M., Nakamura, M., Tanaka, M., Adachi, T., Sugano, M., Ochiai, S. and Osamura, K. |
| Influence of Delamination Location on Mesoscopic Stress State and Critical Current under Bending Deformation in Bi2223/Ag Superconducting Composite Tapes |
| Physica C -Superconductivity and Its Applications, Vols.426-431, pp.1205-1210 (2005). |
| |
31 | Adachi, T., Osako, Y., Tanaka, M., Hojo, M. and Hollister, S.J. |
| A Framework for Optimal Design of Porous Scaffold Microstructure Using Computational Simulation of Bone Regeneration |
| Biomaterials, Vol.27, pp.3964-3972 (2006). |
| |
32 | Tanaka, M., Kawaguchi, T., Hojo, M., Ochiai, S. and Nakanishi, Y. |
| In-situ Observation of Interfacial Debonding Process Induced by Matrix Crack Propagation in Two-dimensional Unidirectional Model Composites |
| Composite Interfaces, submitted. |
| |